Find Your Size
Every Orb Amulet is made for one marble, measured across its widest point. Print this gauge, cut out the holes, and your marble tells you which size to order — no ruler needed.
- Print it at 100% / “Actual size” (turn off “Fit to page”). Lay any credit card on the box on the sheet — if the edges match exactly, it printed true.
- Cut out the five circles on their lines. A craft knife or small scissors; cut on the line, not outside it.
- Set your marble on the smallest hole and slowly lift the sheet by its sides, keeping a little tension in the paper. If the paper lifts the marble with it, move on to the next hole. The first hole it passes through is your answer.
- If it catches before going through, go one size up.
| First hole it passes through | Your size | Marble width |
|---|---|---|
| 19 mm | Too small for this edition | under 19 mm |
| 23 mm | Size 1 | 19–23 mm |
| 26 mm | Size 2 | 23–26 mm |
| 29 mm | Size 3 | 26–29 mm |
| 32 mm | Size 4 | 29–32 mm |
| None | Too large for this edition | over 32 mm |
Still not sure? Email a photo of your marble next to the printed gauge to douxrelics@gmail.com and I’ll tell you. And if it turns out wrong once you have it, I’ll swap it at no charge.
Preview — the printed sheet is true size; the screen version is not.